Electrical power UNITS FOR LIFT TABLE one
Basic Description
This power unit is developed solely to the modest lift table,Consisting of large stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit continues to be extensively made use of inside the market of logistic units for example minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is managed from the solenoid valve with the velocity managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE two
Common Description
This electrical power unit is built solely to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion 
is actived by the solenoid valve and also the velocity controlled through the adjustable needle valve. When the lift rises to a large positoin, however the energy provide is reduce, the decreasing motion is controlled through the manual override function.
Power UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is designed exclusively for your substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as pace managed by a pressure compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE four
Standard Description
This energy unit is created solely for the substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve plus the speed managed from the adjustable needle valve. When the lift rises to a substantial positoin, but the electrical power supply is minimize, the decreasing movement is controlled through the guide override perform.
Particular Notes
one. This energy unit is of S3 duty cycle, which might only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean each of the hydraulic elements concerned before set up of the electrical power unit.
three. Viscosity of the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is proposed.
4. Oil modifying is required soon after the first a hundred operation hours,afterwards when every single 3000 hrs.
five. The power unit proven is built to be mounted vertically.
