1.A connecting hyperlink of an O-ring Chain for standard application is pre-coated with grease on the pins. Prior to connection, verify the grease on the surfaces of pins, and if the level of grease is smaller, apply grease with bare hands. (If gloves are used, the grease is going to be absorbed through the gloves.)
Instance: When the connecting hyperlink (I) of an O-ring chain for standard application is
shipped, O-rings are fitted in the roots on the pins. In case the O-rings come loose as a consequence of vibration for the duration of transport, refit the O-rings in to your roots on the pins.
In this instance, you should definitely return the grease collected with the roots of the pins for the central surfaces with the pins, extra at portion A than at portions B proven in the over illustration. (Portions A is worn as a result of sliding with the bushings.)
2.The chain is often most quickly connected around the teeth of a sprocket. Engage the backlinks at each ends on the chain with all the sprocket teeth and match connecting pins. In the event the sprocket might be moved, the chain may also be connected about the loosened side.
three. Connecting method
one.Verify that O-rings are connected to the roots on the pins.
2.If the volume of grease utilized over the connecting pins is smaller, coat the pins with grease on the central portions.
three.Insert the connecting pins into the bushings with the inner backlinks at each ends.
4.Verify that the grease is applied to your whole encounter in the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins to the connecting plate and when pressing the connecting plate, set up the spring clip. Verify irrespective of whether the head (the end with no split) from the spring clip is turned within the feeding direction in the chain. (See the next illustration.)
six.Make sure to confirm that the spring clip is securely fitted during the clip grooves in the connecting pins.
This completes jointing of the connecting hyperlink. Note that grease over the surfaces of connecting pins and O-rings can be removed for the duration of installation work. In this instance, re-grease applying the grease over the surface of the base chain or even the grease while in the polyethylene bag during which the connecting link was contained.