FMM Style Mill Couplings
The FMM Type coupling consists of 1 conventional flex hub, one particular universal straight bored hub as standard, two sleeves and 1 accessory kit. This coupling is supplied with exposed bolts as typical. Shrouded bolts are available upon request by size 5.five.
Functions
For extended existence
Common 20° strain angle
Heat handled bolts for greater strength
Corrosion resistant bolts and nuts for ease of maintenance
Offers parallel, angular misalignment and end float
Flex Half coupling interchangeable with sector requirements
Extended Universal Hub provided to purchaser specifications with straight or tapered bores
Ordering Information
Application: Driver and Driven.
Style and size of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance concerning shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is required.
Specify counterbore dimensions if preferred.
Submit a drawing if readily available.

FHDFS Sort Floating Shaft Couplings
The FHDFS Kind coupling includes two flex-rigid couplings and one floating shaft. The coupling is supplied with all the rigid hubs outboard unless otherwise specified. The coupling includes exposed bolts only.
Functions
Flex Hubs for lengthy daily life
Normal 20° stress angle
Heat handled bolts for better power
Corrosion resistant bolts and nuts for ease of maintenance
Accommodates parallel and angular misalignment
Elimination of center assembly enables forease of maintenance without the need of repositioning machinery
Rigid hubs outboard enables for bigger shaft diameters
Intended for high-torque low-speed applications that occur in mill operations
Ordering Information and facts
Application: Driver and Driven.
Type and dimension of coupling, horizontal, vertical and so on.
Power: Motor horspower or torque requirement.
Velocity: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Connecting equipment shaft sizes.
Specify which hubs are to become used to the products (Rigid or Flex).
Rigid hubs are going to be made use of on the gear unless of course otherwise specified.
Length of floating shaft may well impact max angular misalignment.