A machine builder required a vertical axis drive to draw, stack and transfer sections of pipe in an essential oil field environment. The application load was very weighty and needed to be transported vertically over an extended distance.

The customer also asked to reduce the weight of the structure while keeping a higher level of safety.
Due to the high loading, ATLANTA offered a multi-drive answer, which shared the load over four pinions running on two gear rack for Woodworking Industry lengths of rack. This allowed a smaller rack and pinion to be used, reducing the weight of the axis drives.

Since accuracy had not been important for the application form, an induction-hardened rack was used. This rack experienced induction-hardened teeth to provide high thrust capability. To insure that the racks remained stationary beneath the high loading, two meter lengthy racks were used to maximize the number of mounting screws used per section and dowel pins were used to pin the racks set up.

The Ever-Power solution met all the requirements from the client and was able to handle the high loading from the pipes being transported.
A milling cutter for a wooden operating machine has pairs of base plates, each plate having a recess to received a slicing put in. Each pair of base plates is installed on helpful information plate, and numerous this kind of instruction plates are installed on a common tubular shaft. Each base plate includes a toothed rack. The toothed racks of every pair of bottom plates engage a common pinion set up on the tubular shaft. The radial distance of each base plate is altered by a screw and the racks and pinion be sure that the radial adjustment can be specifically the same for every person in the same pair of base plates. Make use of – Milling cutters for woodworking planetary gearbox devices.
Linear motion is indispensable to shifting machines; it transports equipment and products efficiently and controllably. The mechanisms that generate linear motion are generally rated by their axial velocity and acceleration, axial forces versus structural quantity, existence, rigidity, and positioning precision.
Two common linear systems are linear motors and ballscrew drives. Rack-and-pinion drives are often overlooked as past-generation technology with limited positioning precision. However, this assumption is invalid.

Precision-ground mounting surfaces to tight tolerances, wear-resistant surface treatments, individually deburred equipment teeth, and small, low-mass designs are boosting performance. Actually, rack-and-pinion drives compare favorably to linear motors in addition to roller or ground-thread ballscrews.
New-generation rack-and-pinion systems provide high dynamic overall performance and unlimited travel range. Some include high quality servogears and actuators with backlash significantly less than 1 arc-min., effectiveness to 98.5%, and far more compact sizes than standard servomotor-gear combinations. Some preassembled gear-pinion units can even run true to 10 µm, for basic safety and smooth motion.